CNC Router 50×24

The machine comes almost complete; the only items not included are the wooden table top and a Mach3 license. The unit was fully assembled and tested then broken down into several pieces for shipping. (Re-assembly will take no more than 30 min to 1 hr). The drive system on the X and Y is a steel-reinforced wide belt system for smooth and rigid operation. The Z is driven by precision stainless steel lead-screw with anti-backlash nut.

* Computer (Laptop with SSD Hard-drive) Windows 10 OS

* Pre-installed Mach3 with Drivers and Profile for the machine configured and calibrated.

* Control box package
* Fully supported Linear Guide Ways on X and Y

* USB Motion Controller board (with up to 100 kHz operation)

* Spindle (Porter Cable 892 Router)

* Router Mount
* 4 Nema 23 Stepper motors
* Pre-wired and ready to plug into the control box

* Cable Drag Chain to keep wires neat and tidy
* Home Switches

* Spindle Relay Module (Automatic on/off of Spindle)

* Wooden Table Top (2 pc. 3/4″ x 24 x 30 MDF or Birch Plywood)

* Copy of Mach3 License